Boat & Automotive Salt Wash

Fill Canister: Add 120-150ml Salt Warrior Boat & Auto Wash to foam blaster bottle

Connect: Attach foam blaster to garden hose

Switch to Foam: Turn switch to SOAP symbol (foam bubbles) for thick foam application

Apply Foam: Cover entire surface with thick foam layer

Dwell Time: Allow foam to work for 2-3 minutes

Switch to Rinse: Return switch to WATER RINSE symbol and remove all foam with clean water

Final Check: Ensure no product residue remains

• Instantly switch between thick foam and rinse with visual switch symbols
• 120-150ml Salt Warrior will clean an average boat, trailer, and gear in one session. Full bottle (240ml) will Salt Wash the towing vehicle as well
• Three rinse patterns handle painted surfaces, fibreglass, and metal components

Mix Solution: Add 50ml Salt Warrior Boat & Auto Wash to foam cannon bottle, fill with water

Connect: Attach foam cannon to pressure washer lance

Apply Foam: Cover entire surface with thick, consistent foam layer

Contact Time: Allow 2-3 minutes contact time for salt dissolution

High-Pressure Rinse: Remove all foam with clean water rinse

Final Check: For the perfect finish, use a quality microfibre towel to remove any remaining water spots and restore that showroom shine

1. Connect Hose: With mains water turned OFF, snap garden hose fitting onto the back of the Spray Nozzle

2. Set Controls on Spray Nozzle: Ensure both control taps are turned OFF:
• Turn LARGE water flow tap clockwise to 12 o'clock position
• Turn SMALL soap flow tap clockwise to 12 o'clock position

3. Water Pressure: Turn ON garden mains tap to approximately 75% pressure (adjust higher if needed)

4. Start Flow: Holding bottle securely, rotate LARGE water flow tap counter-clockwise to ON to start water flow

5. Introduce Foam: Rotate SMALL soap flow tap a few degrees counter-clockwise to introduce Salt Warrior into the water stream

6. Adjust Foam Density: Balance water flow and Salt Warrior pickup by adjusting both taps to create thick, rich foam coverage

7. Apply: Thoroughly saturate all surfaces. Areas with heavier build-up may require longer soaking time

8. Stop Flow: Once completely covered, return SMALL soap tap to 12 o'clock (stops foam), then return LARGE water tap to 12 o'clock (stops water)

9. Contact Time: Allow 2-3 minutes for Salt Warrior to dissolve salt deposits and loosen grime

10. Final Rinse: Turn LARGE water flow tap back ON and rinse thoroughly with clean water, ensuring all foam and suds are completely removed

11. Final Check: For the perfect finish, use a quality microfibre towel to remove any remaining water spots and restore that showroom shine

One 2L bottle provides multiple washes for average boat, trailer, and towing vehicle combinations.